The chart gives the frequency of lubrication in hours, based on normal operating conditions. Additional warning and operating decals are available at no extra charge. Raise and lower the mower with the 3 point hitch to find the position where the driveline is shortest. Be certain all moving parts on attachment have come to a complete stop before attempting to perform maintenance. Checking to see if front weights need to be added to the tractor in order to maintain balance. The GM21 series mowers can be used with a Quick Hitch system, allowing for quick and easy hookup, by installing an optional adapter. Test run, check for excessive vibration or overheating of bearings. Never raise the mower until all blades have come to a complete stop.

All decals properly located and readable see fig. Do not start or stop suddenly on slopes. Adjust tractor top link to allow the mower to follow the ground contour and yet remain as level as possible when raised to transport position. Remove the M16x bolt on top of the three point hitch of the grooming mower. If necessary remove and replace the bearings from the rotor using presses or extractors. Once engaged and ready to start cutting, raise PTO speed to rpm and maintain throughout cutting operation. Be careful when changing directions on slopes.

Grass condition, wet or dry. Always keep all three blades sharpened equally in order to maintain balance. Raise and lower the mower with the 3 point hitch to find the position where the driveline is shortest. The blades must be mounted with the cutting edge in the direction of rotation and the lift wing edge towards the bottom of the deck see fig.

  CINEMA TEATRO METROPOL CORIGLIANO CALABRO

To do this, shorten the moewrs top link until the top hitch plate is locked forward and no longer able to pivot. Tighten the locking nut while turning the spindle.

Turn the adjustment bolt clockwise until the proper belt tension is reached.

Account Suspended

Stay clear of rotating driveline. Use extreme care and maintain minimum ground speed when transporting on hillside, over rough ground and when operating close to ditches or fences.

See Replacing Belts section. Before starting to mow, never forget that the operator is responsible for the following: Install the floating yokes in the same hole that the hitch pins were mounted. Mow extremely tall grass twice.

John Deere GM2109

Increase tractor rpm, check engine and PTO speeds. If necessary remove and replace the bearings from the rotor using presses esries extractors. The belts for proper tension. The spindle bearings have been greased. Make no repair or miwers with the tractor engine running. Grease all areas indicated under Maintenance. Lower mower to the ground with the tractor rock shaft control lever. Remove front nuts holding central plate.

Allow no riders on tractor or mower.

It is up to him to assure that the machine is in perfect condition and ready to be used. Refer to your tractor manual for PTO engagement and disengagement instructions. Daily and periodic lubrication, maintenance and inspections. Attach the driveline chains fronteir the tractor and to the mower to keep the driveline protection from turning. Adjust tractor top link to allow the mower to follow the ground contour and yet remain as level as possible when raised to transport position.

  FLAME OF RECCA EPISODE 13 ENG DUBBED

Wearing sturdy, tough-soled work shoes and protective equipment for eyes, hands, ears and head. Our grooming mower comes equipped with 4 swivel wheels.

Replace them if necessary.

Test run, check for excessive vibration or overheating of bearings. Frontie on the lock nut. This can cause damage to the mower. Reduce speed on slopes and sharp turns to minimize tipping or loss of control.

Cutters & Shredders | Frontier GM21 Grooming Mowers | John Deere US

With rubber mallet, tap on the top of the spindle to set the bearings. Before working on frontidr machine, disengage the PTO, shut off the engine, set the brakes, and remove the ignition key.

Once engaged and ready to start cutting, raise PTO speed to rpm and maintain throughout cutting operation. Blades properly installed, blade bolts and nuts tightened. The roller is particularly helpful when grioming over uneven terrain.